Firefly Energy

Ringwood & BH24

Electrician in Ringwood

Electrical work in Ringwood, Poulner, St Leonards and Burley — repairs, fuse boards, inspections and new circuits.

Get in touch and I’ll talk you through what’s involved.

  • Repairs, boards and inspections
  • Free, no-obligation quotes
  • NAPIT registeredRegistered competent electrician
  • Fully insuredInsured on every job
  • 15+ years' experiencePeter has been doing this a while
  • Covering BH24Local to you

Services

Electrical work in Ringwood

Electrical services in and around Ringwood

Ordinary jobs make up most of the work: finding a fault behind a circuit that trips, dead sockets and lighting, worn switches and fittings, extractor fans, and replacing a fuse box with a consumer unit that has proper RCD protection. Inspections too — an EICR for a sale or a tenancy, and the certificates landlords need. Additions are frequent: an outside socket, garden lighting, a cooker or shower circuit, a charge point on the drive, and rewiring where an older house has come to it.

You get one electrician for the whole job, NAPIT registered and fully insured, with the price agreed before anything starts. Quotes are free.

A Hampshire town with a BH postcode

Ringwood is in Hampshire, on the western edge of the New Forest, but its postcode is BH24 — the same letters as Bournemouth. Now and then that leaves people unsure whether an electrician from the Hampshire side covers it. I do: Ringwood and Poulner, and the BH24 places either side of the county line, from St Leonards and St Ives to Burley. The A31 makes it an easy drive from Eastleigh.

Homes where the heating is electric

Not every property around here is on mains gas, and where heating and hot water run on electricity the installation carries far more load. Storage heaters and an immersion on an off-peak tariff usually mean a second, time-controlled supply alongside the normal one — often a small separate board, or an unlabelled switch near the meter. Replacing storage heaters, changing tariff or having a heat pump fitted all change what the board and the incoming supply are asked to do. The heating is the installer’s side; whether the electrics can take it is mine.

Extensions, outbuildings and future loads

If you’re extending, converting a loft or fitting out a garage or garden office, the wiring is cheaper and tidier planned early. The circuits go in while everything is still open, we agree the positions before the plastering, and I check the board for spare ways and protection. A building away from the house needs its own supply, sized for the distance rather than borrowed from the nearest socket.

If the heating is electric, or you’re thinking about a charge point, it’s worth adding the loads up first. A charger, a shower and storage heating are each fine on their own. Together they can ask more of the supply than it was built for. That’s down to your board and the incoming supply rather than the appliance itself.

Not sure where to start?

Ring and describe it in your own words. After 15 years it doesn’t take long to work out whether you’re looking at a repair, an upgrade or a bigger piece of work, and to tell you straight which parts can be left for now. The quote is free. Let’s have a chat.

Coverage

Areas around Ringwood

Towards the coast

Questions

Ringwood questions

One of our boards is labelled off-peak. What does it run?

Usually storage heaters, an immersion heater or both, set to use cheaper overnight electricity. If you have changed tariff since it was set up, it is worth checking that it still switches when you think it does.

A heat pump is going in. Will our electrics cope?

Often, but not always. The heating installer will say what supply the heat pump needs. I can check whether the board and the incoming supply have room for it, and where they do not, the network operator may need to be involved before it goes in.

Electrical work in or around Ringwood?

Tell me what it is and how the house is heated, and I will come back to you.

Call Peter Get a Free Quote